Why would you do that when HP's, CV-1's or Tiger's can do that with little or no work at much less cost? I think Edelbrock has totally missed the boat on this release. An as cast port at 3.2 sq in at 400 cfm with the ability to port out to 460 or better might have a small market. With HP's, CV-1's, Tigers and W-6 heads available, they will have a HARD time paying off the tooling bill for these heads. It serves them right for being late to market with a very similar product line to KRE, 5 years late. They seem to be 5-7 years behind the market and the times.
Quote:
Originally Posted by GTO
Is it possible to go to 380-390 cfm and digitize the port and then go on to bigger and better for the big boys? Then you would have a head for those of us looking for a good head using our old stuff, rockers, Victor etc. Like killing two birds with one stone. ... Eric.
|