Quote:
Originally Posted by 65nss4spdGTO
I'm actually offended by this comment. First off, we have a port that is pretty decent, but it doesn't exceed my CV-1 head, KRE HP's I've worked or the Tiger head coming from AP. I also had a new set of 12.6's for sale almost a year ago, no takers here on this board when at the time, no one else could get them. As far as the amount of time we have in this port, it would cost well over $5K to cover the hours spent in development and we don't have the port digitized for CNC yet.
We should be able to post final flow data and final pricing by the end of next week, at this point we have a head flowing:
216 cfm @.300
347 cfm @.500
441 cfm @.700
Thanks.
Calvin Hill
Hill Performance / Mondello Tech Center
708-250-7420
|
Calvin - there was no offense intended - but I stand by my comment that on this thread and the other about the 11 degree head it seemed that there was a lot of resistance to start the development process and now there are a number of guys working on it. with a 12.6 and an 11 degree head being offered I can see why there would be little interest in the 12.6 -- We have all been there - as soon as you lay down the money for them you find out the 11 degeee is much better -- jmo. I was wondering if you would clarify your statement above - are you saying all the heads you listed have better numbers than the flow numbers you just listed ???