The rear edge of the core support is is welded at a bad angle. it requires drilling out 6 or 8 spot welds that hold the top of the new support to the uprights, repositioning the top about a quarter inch higher than were the repops are welded from the factory. This 1/4" translates into close to a half inch at the rear edge.
It's not a big deal. It's also not PY's issue, they are selling the same chinese part that everyone else is. It takes about ten minutes to fix.
We have installed dozens of these supports, I consider them a nice piece.
__________________
Paul
FAST Automotive -The Pontiac restoration shop, not the fuel injection guys! I had the name first.
My site... needs updated-
www.fastrestorations.com
68 GTO's (RA II, RA I, HO, convert, Pro Street, Racecar, etc.), 2 69 GTO Judges, 70 GTO racecar -10.77 @ 124mph, 68 Tempest survivor, 3 03 Aztecs!
|