Looking at my skins, they don't have that small section you circled in your pics.
I had thought (prior to checking the repop skins) that the body-line was only from behind the rear wheel opening (back toward the rear bumper). However, looking at some pic's of the full repop 1/4 (not the skin) for comparison, it seems the quarter does have more sculpture at the lower edge (at the door-jamb).
Someone on the board mentioned (previously) about reproducing that line (in the rearward section) - i.e. on the repop-skin. I wondered how they went about doing that? My thought was to try and take some dimensions off the original - to be replaced panel (i.e. width X height, transition angle from top to bottom, tc.) - and try to transfer this onto the repop-skin. I am not sure the lower body can be reproduced at the front edge (near the door jamb).
Any thoughts greatly appreciated.
Brian.
|