I am attempting to prime my motor but am getting no oil through the push rods.
Several weeks ago, I attempted to prime with a flat head extension on my drill while the motor was out of the car. As soon as I started, some assembly lube started to push out but about 10 seconds later the bit fell into my oil pan.
After draining the oil and pulling the pan I decided to wait until the motor was in the car and use a proper rod.
Fast forward to no.
After several minutes of drilling with an actual priming rod, I am getting no oil out of any pushrod. I have rotated the crank multiple times.
Double checked the direction of the distributor and that there was oil. I am slightly worried this could be a major problem.
Drill I am using is a new 6 amp black and decker w/ cord.