Thread: No oil while priming
View Single Post
  #23  
Old 01-13-2012, 01:29 AM
pugslyx234 pugslyx234 is offline
Chief Ponti-yacker
  
Join Date: Dec 2004
Location: washington state
Posts: 620
Default
I think if its getting hard to prime then its good. I always feel by hand that its getting tough to turn with a screw driver then good to go. You didn't perform a full rebuild so get it fired. Did you do the Cam bearings? I may have jumped the gun if you installed them incorrectly. Woody

Last edited by pugslyx234; 01-13-2012 at 01:34 AM.
Reply With QuoteReply With Quote