Quote:
Originally Posted by John Langer
You want a bigger bore spacing block. Buy a dart bbc with out head bolts and cut and move a pontiac head to fit the bore spacing. If there is a sheet metal intake on it I assure you that only the trained eye would know what block it is. CFE can do the head mods. Just sayin'...
|
Totally Agree, John. If you were running a Belt Drive and a Front Plate, even fewer people could tell the difference. They would see the Pontiac Head Castings and say "Pontiac Engine" but might not pick up the "spread bore", (especially on a special CV-1/ RA-V type head).
Tom Vaught
__________________
"Engineers do stuff for reasons" Tom Vaught
Despite small distractions, there are those who will go Forward, Learning, Sharing Knowledge, Doing what they can to help others move forward.
|