Here's some pics of the kit install on the car in Austin this morning. We lost our shade mid morning and it started getting a little warm so we didn't complete the letters or nose bird.
Installation tips:
Begin with a concour correct TransAmStripes.net stripe kit.... Ha.. had to get that in
A. Install the stripes in a cool dry location. As in our case, the sun caught up to us and we couldn't finish.
B. Use RapidTac. I can't say enough good things about this product. Turns a tricky project into a smooth one.
C. Use a seamstress tape to center the stripes. Easy to use and easy on the paint.
D. Use a grease pencil to create match marks for positioning the decal on the car. Blue tape is ok to temporarily hold the stripe while your positioning but comes off with the application fluids.
E. Squeegee the fluids and air out of the stripe working from the middle to the edge methodically, covering all of the stripe, first lightly, then firmly.
F. When removing the transfer paper, do not lift up on the paper. Instead pull it back low across the surface. This will prevent the stripe from lifting from the car.
G. Overrun in the shaker opening: You can ensure proper alignment of the shaker overrun by viewing and positioning the shaker opening from the underside of the hood. After the hood stripe is installed, there should be an equal overrun of stripe around the shaker opening. Prior to completing application of the shaker opening overrun, move the car into the sunlight to warm the stripe. The heat will naturally curl the overrun down towards the shaker opening. As the stripe warms up and curls, it can be easily fitted into the shaker opening. A spritz of RapidTac or detergent/water solution will help with this fitment. The result should be a wrinkle free, clean application of the stripe overrun into the shaker opening.
H. If a bubble appears, be patient, and after completing the install, move the car into the sun and let the stripes rest. As the stripes heat up, the bubbles will shrink, and can be carefully pushed down or out with your fingers. Do no try to force the bubbles to the edge after you have a good seal on the adhesive. As a last resort, a pin prick will release any trapped air or fluids.
With all that said, here's a helpful video also:
http://www.youtube.com/watch?v=qMo2A...are_video_user
Good luck everyone with their installs!