[GP Fan]

I also installed a PYPES 2.5 inch dual exhaust system with racepro mufflers. Went in OK. Made it a lot easier because I installed it when the body was off the frame. I dont really know how to weld so I just used clamps to mount it. Doesnt look as good but they are holding everything together so far. Will see if it leaks. I had to mess with it for awhile once the body was on to get the tail pipes where they looked ok. Will pry cut them off at a 45 degree angle. Should I use anti seize on clamps to keep nuts from seizing up due to the heat or will it be ok without? Once again, I was in a hurry and did not take a picture of the frame with the exhaust mounted!
All comments positive or negative are welcome.