Quote:
Originally Posted by 67'7F6'Bird
I've seen the headers first hand when they arrived and they "Do Not Fit" with the Valve covers prescribed and supplied for the build. You can't even get a side bolted on completely to the heads or get more than a few bolts/studs to fit at one time on each side. Also, the tubes are crooked, minimal effort was applied in the tube to tube welding with bad angles were each section meets the next, steps created at junction points, overall Very Poor Quality welding. Basically they SUCK.
|
Possible that the flange screw locations on the mockup heads don't match the actual heads on the engine build? That wouldn't be the fault of the fabricator, it would be the quality control on the head flange machining. Just throwing it out there. Guess I'm just a redneck hack like everyone else in Indiana and I'll keep the rest of my opinions to myself.