Quote:
Originally Posted by 2manyponchos
Possible that the flange screw locations on the mockup heads don't match the actual heads on the engine build? That wouldn't be the fault of the fabricator, it would be the quality control on the head flange machining. Just throwing it out there. Guess I'm just a redneck hack like everyone else in Indiana and I'll keep the rest of my opinions to myself.
|
Some of the tubes and the bends on them are so close to the flange you cant even get a bolt through the hole unless its put in from the wrong side of the flange. However, you bring up a Good Point of "No Quality Control" with regards to the heads. I would Agree.