Quote:
Originally Posted by Jim Robertson
Some progress...at least they are back in our hands for the next phase.
If you read some of my earlier posts we ran into an issue where the end exhaust ports required a totally different port than the center exhaust ports. Now a standard o port header flange will line up nicely even though Edelbrock moved the valve centerlines.
|
Wow you are thin between the intake ports at the flange. <<Not knocking , just saying.
How thick are you to the machining for the plug socket? <<This spot really pissed me off.
I had to weld the tops of ex ports at the flange because there was not enuff material to even seal up a 2 inch header , with bolt holes in the stock location.
Just went after my heads agian, ported the whole dam things all over agian.
