Heres food for thought, I like to install & adjust my rockers with the valley pan off so I can look at each lifter as it rolls on the base circle of the cam. That way I can see it & know it's on the base of the cam when I adjust the rocker arms. I do them one at a time starting with either number 1 or 2 cylinder & roll it around to each base of each cam lobe, that way I can see it on the base & know for sure each one is done correct. It takes a little longer to do it that way but this way I know it's done right. Then when you start it up they are all right where they should be so when everything is put back on all you need to do is start it up & either break it in or go out & drive it.
|