Quote:
Originally Posted by Dick Boneske
The fitting used by the factory is pictured below--screwed into the center carb throttle base. It's a brass "T" fitting. The driver's side goes to the distributor for vacuum advance. The passenger side goes to the air conditioner controls via a 1/8" pipe that attaches to the rubber hose to the firewall. Note that there are several styles of "T" fittings. The '61-'62 versions were short, the '63 and early '64's were long like the '65, but used a smaller line for the a/c.
You can see it in the upper left corner of the second picture on a '64 Tripower. The last picture shows the pipe stub that connects to the a/c on a '65 Tripower.
|
Thank you so much. Pictures are worth a thousand words. Any idea where I might find one of the long "T" fittings?