Finished the radiator mount and the top shroud piece. I made a 1/2 by 1/2 square tube surround for the radiator opening, made a flat sheet metal top with the opening to match the radiator opening and bent the sheet metal around the 1/2 by 1/2 tube frame. Next I'll make sides from the top down to the trunk floor and use foam to seal it all in. The dual fan shroud bolted/sealed up to the bottom of the trunk floor will then pull all of the air thru the radiator and out under the car. I still have to take the trunk lid to the guy that will put in the louvers.
I also bought 2.5 inch polished stainless 180 degree tubing and had the welder that I go to weld on the V-Band flanges.
This how it will install and come up over the frame to the turbos. The second set of 180's will get cut in half and the now 90 degree bends will get welded back on in as "S" shape to match up to the turbos. The pic shows the header installed with the first tube coming up. The second 180 is just setting in the flange. I have to take it for cutting and welding yet.
I have a Crusie/Car show this weekend so I hope to get that front grill filler panel from the powder coaters by tomorrow.
Mark L