I wouldnt run the factory windage tray... they are prone to cracking. Under 6000 rpm I dont think I'd bother... but a higher volume pan would take priority... Canton has some nice pans and sandwich mount windage trays...
Careful on your cam pick... you dont need much. It's not uncommon for tq to peak @ 500 rpm sooner and hp to extend @ 800-1000 rpm later over NA. Not optimum but an 068 works ok on a 400 with a turbo but an 067 might be better on a smaller motor
A custom grind would be far better. Travis can set you right with that better than I.
|