[67drake]

Originally Posted by gto4evr

I run a two pod gauge under the dash using one of the screws holding the bottom of the ashtray bracket in and maybe one other hole drilled up underneath to hold it from twisting.

Car's in the storage tent buried in snow right now, this is the only pic I could find in the archives, not a good shot, but you can see them if you squint!

I'll have to look into that area. I didn't know if I'd have enough room or if it would interfere with the ashtray. Looks like I don't have too many options though. Thanks for the pic!

Originally Posted by bdk1976

I remember seeing someone use a couple of clips off or tape measures on the gauge housing so they didn't have to drill the dash - seemed like a good solution. I think the post was either here or on CP quite some time ago-might find it with some searching.

I did a search here and over on CP and didn't find much. Thanks for the tip though. Interesting idea.


Falcon,yes that looks great,but I'm looking to not stray from original as much as possible.