Quote:
Originally Posted by Formulabruce
The PY bracket/bushing holder is no reproduction. Its a GM part for a truck/car. ( not ours) That said, it is NOT the 1995 3/4 ton diesel suburban bracket, THAT is discontinued. ( Idea on this from NJ Steve). The '95 'Burban bushings are available and are 1-1/8th, and although not big enough, are a bit Tall, and do have the typical powder on the rubber. Of note, they DO have the correct "nub" on the bottom that fits in the "indent" in our subframes. I feel its a bit long/ tall? , even if I could find a way to make the hole bigger in a uniform fashion. See pics.
 |
bad P.Y. for lying!!!!I will pull my bushing and post a pix and I will measure the inside hole...mine definitely did not have a centering hub...early in this thread are pix of the front end underneath and my install was fine...let me pull a bushing and then we will know!!!!!