[Nicks67GTO]

Well let the fun begin. I have the whole week off to get this done so im hoping I can get it almost ready to roll by the weekend. It was nice enough to drive my GTO to the garage and start on the frame swap. Here she is around 11am and then again around 4pm. The engine is ready to pull right away in the AM. Lots of little things done today. The front sheetmetal is obviously gone, along with that the headers and exhaust, drive shaft, shifter and linkage, clutch linkage, radiator, ebrake hardware, harnesses, gauge connections, are all out.

Im hoping I can get to get the old frame out tomorrow but we will see. I need to pull the steering column, rear axle, fuel system, brake and gas lines, and break the front suspension down before any of that happens.....Ill probably be updating daily as I go.