[Nicks67GTO]

Well day 2 is in the books. I didn't quite get where I wanted to again but its coming along nicely. I yanked the engine/clutch/tranny, fuel system, brake system, rear axle and the entire chassis out. I'm down to the frame, shell, and front A arms. The A arms will be out in a half hour tomorrow morning than its time to swap frames.

I think i'm going to use 4x4's to span the underside of the car and put a notch in them for the underbody pinch point. Ill be keeping jack stands as close as I can to the shell while the frame is out, basically keeping most of the weight on the jackstands and not stressing the 4x4's as much. Ill use a cherry picker and tow straps to pick the shell up to get separation, slide the 4x4's in and set them on the jackstands. Then lower the frame pull it and then just reverse the process. Sounds easy enough but we all know how things like that go. Anyhow here's a few shots of todays progress. Remember I drive the crap out of this car so stuff gets chipped and grimey....