Thanks for the info Bruce. I cannot do full depth at the front as a small crossmember goes underneath the pan. I have closer to 3" of clearance between the boat and pan at the rear though and could increase the depth for about 2/3rds of the pan.
T money-I found them online but noticed no pontiac stuff, I will call them on monday.
69goat1- it's a 17ft and supposedly a biesmeyer hull although everyone that looks at it says it isn't. No one can id it either, most likely a one off deal most figure. It was built for circle racing and had a ford engine in it prior to the previous owner switching it over to pontiac.
Sent from my iPhone using Tapatalk
__________________
Derek B.
Current best: 11.97@110 1.65-60' !!!
'74 ventura,  (Fired july 14/06) '74 462 4-bolt (9.5-1), SCAT, Ross, T-II w/850DP (shaker455), TH350, Conti 10'' 3800, Supercomps, Magnaflow, 3'' Pypes, 3.73's, 28x13.5-15 ET streets.
1970 Beismeyer 17' flatbottom vdrive, 11.8:1 455P, ported heads, dual Qjet tunnel ram.
|