[HWYSTR455]

Originally Posted by Held for Ransom

Thanks, but I don't think I like that set up (probably just me).

Back to topic.
Post #12 asked which kit you used. This was important as the kit for a '66 (tines lay flatter) is different than a '70s kit. And, was the TO bearing to fork inserted correctly?
http://s7d9.scene7.com/is/content/GenuinePartsCompany/1550250pdf?$PDF$

Yeah, the bearing was installed correctly, you can see it in the pic in post #16.

I commented on the bearing types too, depending on tines, how the edge of the bearing needs to be rounded. The difference between pressure plates, or tines, kind of doesn't matter, as long as you have the correct height throw out.

99.999% of the time, it's a throw out issue. And just about the same percentage, I've seen the listing for the bearing in parts catalogs wrong.

.