Quote:
Originally Posted by Brewster
|
You had me confused there for a minute, then I figured out you meant the ebay link. Thanks for the tip. I scooped it up.
Well, the motor is almost done, but it was more two steps forward and one step back today. The poly locks with the PRW rockers are too tall for the stock valve covers so I've got some shorter comp cams locks coming from Summit. Hopefully the comp locks and a thick gasket will get me the needed height. Regardless, until this is resolved the valley pan and intake cannot be bolted down which stops progress again. It's looking good though and will be right once it is finished. Tortoise and hare stuff.
Here are a few pictures...
