Quote:
Originally Posted by Pontiac Derek
The RPM is much better than the performer or P4B Q jet flange, Especially ported, you will gain 10hp up top but lose 10ft lbs down low with a 1" open spacer, a 1" open spacer will net you your best et's and you will be right there with a T2 that is untill the T2 is fully ported with a 1" open spacer fwiw
|
Thanks I gasket matched my rpm intake to my heads,blended it back about 2 inches.I don't think this intake will make more peak power than my Torker 2,but will it make up for the peak horsepower loss with the higher torque numbers down in the rpm range?My torker 2 ran its best with a one inch tapered 4 hole Wilson spacer,you could actually feel the torque difference and throttle response over a one inch spacer.