Turn signal clean up
Well it looks like I have found a source for the components to fix the light sockets on the turn signals and my rear courtesy lights that fo on the rear armrests. The wire is a little light in my opinion, but I get the components I need. I found the sockets at AutoZone. One had a boot that I can use on the turn signal. I will probably use some heat shrink on the boot since I have two wires exiting one hole on the boot. The original had individual exits for each wire.
For the rear lights I will have to cut the wires and add spade connectors so I can feed the wires through the insulators. Same with the turn signal wires, unless I can disengage them from the plug on the other end.
Lastly, anyone have any suggestions on replacement lens gasket material? This one is hard and sticky, but complete. I suspect it should be more pliable.
|