[Scarebird]

Originally Posted by NeighborsComplaint

Just a quick update. I just installed my rebuilt third member and went to install my rear disc kit. Not exactly the bolt on kit I thought I had bought. There are tabs to terminate the rear axle hardlines and connect to hose to the calipers that must be welded to my fully painted rear axle ... my newly installed axle bearings and seals will have to be removed and replaced to allow machining. The shop says new bearings and seals will be needed as the newly intalked ones will likely be damaged pressing them off.

I am assuming it is not our kit because we weld soft line tabs on every rear kit that can use them.

Also, your machine shop can turn your axle flanges WITHOUT pulling the bearing or sealing - it will just be noisier...