Thanks John. I think it is 1 1/8 as in 1-1/8", likely for the bore diameter??? The master cylinder has already been delivered to the powder coater, so I don't have it handy to check. Once it comes back the numbers should be a little easier to read.
MPD also delivered the M22, shifter and reverse lockout linkage to Dennis Maroudas for rebuilding and replating. Dave was extremely impressed by Dennis's shop, friendliness, and the quality of work he saw. That says a lot because MPD is a little picky. Dennis is going to go through the tranny and check everything out, rebuild the shifter, and replate the shifter, mounting bracket, linkages, and reverse lockout linkage. Also, all the fasteners in the transmission had been replaced with stainless bolts and Dennis volunteered to switch those to original bolts from donor transmissions he has on hand. Pretty cool.
Here is Dennis's contact info:
Dennis Maroudas
DME, Inc.
phone: (606) 237-6648
internet:
[email protected]