[gtofreek]

Honed the block with a torque plate. Sorry the photo is blurry. The hone was running when I took this, so I guess the camera couldn't decide what to focus on.





The cylinder on the right has been plateau honed, the cylinder on the right has not been yet.



The front of this block looked really crappy. I could not stand it, so I took a Scotchbrite pad on a flat steel block, and scrabbed it clean, and gave it a nice swirl finish. Looks much better now. Guess I should have got a pic of it before, but I didn't think about it.



Done and awaiting cam bearings, and to go on the engine stand.





On the stand and ready to be built.