I just watched about 4/5 videos on you tube and I replaced my lower pinion seal. A pitman arm puller can be rented from auto zone if you have one near.Get the larger size. tighten the puller down tight and then hit the head with a big hammer and that should jar it loose. If not tighten some more and hit it again. Just pull the box off the car and make sure you replace the rag joint if it is old. It comes loose from the box by removing the bolt and then use a chizel to spread the clamp a little bit. Make sure you mark the shaft and box so you do not mess up the turn signal canceler in steering column. I took the 4 bolts out and pulled the shaft out and cleaned the surface that the seal rides on. If you follow the you tube videos and use common sense it should not be too hard. I reused the rubber seal on the top, I just used a little grease to hold it in place.
__________________
connman
|