I'm in the building a new engine stage. I have a 469, 455 .60 over with the Ross/Butler pistons & Eagle H-beam rods. So far when they get the pistons the block will be matched to the pistons & decked so I have the pistons at 10ths in the hole. I have E-heads (round port) & there has nothing been done to them yet. The crank is a new Eagle cast 3.25 inch. I'm hoping now that with the info you will be posting I can make a little bit more HP then when I had the SRP .30 pistons in it with a Crane Blue Print RA IV cam. It made 523 HP at the crank with those pistons & cam with the Performance RPM intake & RA exhaust manifolds & a Pertronix ign. with a tricked Q-Jet. I hope watching this thread I'll get some great useful info to make even more.
|