Quote:
Originally Posted by 400 4spd.
Might be able to with the rear body panel (tail light panel) removed.
|
From another post (don't remember which one now)
"I have already installed the 1 piece trunk floor in my 67 gto, It fits awesome!!!!!! the only mos needed is at the tail light ass. it is shaped different than the gto, I just just a flat seam 5" forward of the tail light ass.. the area where I spliced it is right in the middle of the rear (5th) cross brace, so It is impossible to see from outside the car!!!. on the inside of the trunk it is butt welded together; I then ground the weld down flat & leaded the seam.(you can use plastic filler instead).
the weld seam is 100% unnoticeable, all the other sides of the trunk floor place were spot welded in, like the factory did. This is a excellent fitting piece!!!!
one last note!!, You will NOT be able to drop the panel into the "trunk" area by opening the trunk lid! You will ALSO have to remove/replace the tailpan (which I did replace). the only other way, it may be possible to install.... is from the bottom side of the trunk, if the body is not on the frame!.(I would not recommend doing it this way!,)
IMO it is better installing the panel while the car is still on the frame, and u have the body bushings in place, to make sure that the panel is installed correctly."