I did not really disassemble the ebrake. I removed the switch, spring clip, and spring, but these things are riveted together and I wasn't going to mess with that. I bead blasted the whole thing and then after scrubbing and clearing used 3M 1/4" vinyl tape to establish the line for masking. You can get this at Napa and it is great for tight places, curves, et cetera. Then just use regular quick release tape and mask everything else as best you can. I stuffed a paper towel up into the backside of the pedal arm. Some of the satin clear pulled with the tape, but you can shoot right over it and it blends invisibly. Good luck.
|