So to specifically cover the conversion topic, B-Man brought up a good point. By just lowering the non AC lower brace by 2", the brace will protrude below the bumper and probably won't look good.
Our plan would be to duplicate the bottom of the AC support.
Here's the simplest of instructions.
1. Cut your non AC support just below where the main upper part of the support ends.
2. insert our new AC bottom brace conversion.
3. Weld or bolt to the existing non ac support.
The new conversion will not hang down any lower than factory and it will be very difficult to see that a conversion has been made even upon close inspection.
__________________
---------------------------
Fool Around, Get Hurt, Don't come Crying to me.
|