Quote:
Originally Posted by dataway
The typical Moog bushings have a dull zinc plate on them, at least that is what it looks like to me. It's not paint anyway, nor is it bare steel.
Purely .... where did you get the lock nuts you used under the nuts? I noticed the Ames kit doesn't include them. I have a selection of black oxide lock nuts, and some shiny zinc ones, but the factory stuff was usually that dull gray zinc.
I used that POR Cast Manifold Gray on my exhaust manifolds ... excellent stuff, at least the way it goes on, covers and dries. Haven't run the engine yet.
|
Interesting, here I though the Moog bushings were bare steel. I see my local autoparts store has the upper fronts in stock, I'll stop in there & take a look. I have seen several google images of new ones where rust can be seen. Made me wonder. Maybe install them & brush on some rust prevention magic for good measure? I'm going to order some of that soon & see if its as good as they say. When I restored my chassis the first time around I installed energy suspension bushings to stiffen up the car a bit. Now I am not so sure I care about that anymore. I love the clean look of the yellow cad finish, but its so obvious what they are. I initially bought them to try & prevent wheel hop.
I used a coating on my manifolds that was supposed to be like a porcelain based paint. It looked great & seemed to hold up well. Even after breaking in my camshaft, nothing burned off, they looked exactly the same. However, fast forward 10 years & they are rusting again. Never run, or driven. Just started up a couple times over the last decade to keep the engine lubricated inside.
I am going to send them out to have them ceramic coated this time. Just not sure where yet. Found a few places here in Wisconsin.