Hi
Not sure if I already posted his question .
Should I remove the bar and ball from the accelerator pump area and install the orange umbrella rubber piece ? Is that considered a decent upgrade / reliability action ?
One last question, the dowel pin on my metering block broke off . The block itself is not warped , nor is the center cention . Checked with ruler.
Is it possible to still run it and it work correctly with one dowel pin and the 4 screws holding it on ?
__________________
69 Gto, 390 posi gears,th400 w/jim hand converter/406 pontiac/#64 HEADS/ 10:1 compression/ 190 PSI with/ TRW 160 thou domes / hooker headers 1 7/8, PRW 1.5 rockers, 405 Crower Springs, Holley 750 vac with proform upgrade, Performer RPM on points / 284 H Single Pattern Crane
|