Quote:
Originally Posted by 68 461 Bird
I have heard this several times before and I am in agreement, but a lot of people seem to agree that the "lead substitute" is necessary if you are running an old engine that hasn't been upgraded with the hardened valve seats. What are your thoughts on this?
|
My experience is that it is totally unnecessary. I've run numerous non-hardened seat engines for many miles on modern fuels with no additives, and have disassembled many more, and have seen no conslusive evidence that there is anything to worry about on a street engine. I think it may be more of an issue on race engines, maybe on higher compression engines or engines that are regularly driven hard, but on my street engines with lots of miles I haven't seen it be an issue. Again, my '71 455 with 241k, never used any additives, and all but one of my valve seats looked pretty decent still. The one exhaust seat that was bad was on a cylinder that was running a little low on compression due to tired rings, and that cylinder was burning a good bit of oil. I suspect that contributed to the exhaust seat pitting, as the others all looked good.
I've taken apart a bunch of virgin, untouched engines that showed no sign of excessive valve seat wear either, despite running tens of thousands of miles on modern fuels. I think it's much ado about nothing, to be honest. I've seen too many engines run too many miles and have too little wear to think there's anything to it.