Well I’ve got an update on where I am at. Painful. So I made the mods to the divider plates and bolted everything back in. I add antifreeze and the pump seems to be leaking at the bottom of the pump housing where the studs and nuts are. I thought I had torqued enough but I guess not. I start to slowly tighten those nuts more, the leak starts to lessen but does not completely go away. The nuts feel way tighter than they should be but I press on carefully and disaster strikes. The housing around the middle nut on the bottom cracks. New flowkooler worthless.
Have others had problems with the bottom of the flowkooler housing sealing? Any advice as I try this again with another pump that is in the way?
|