Quote:
Originally Posted by Stan Weiss
Dragncar,
4.25" - 4.23" = 0.02" but only half of that is going up. So if you are now zero deck that should put you at 0.010" down in the hole. So you could just reduce your head gasket thickness by 0.010"
Stan
|
I am going to need to mock it up and double check everything. Sometimes I ask questions and already pretty much know the answer. But there are some highly experienced machinists/engine builders who post here. Their opinions never hurt.
I have a 1016 Fel Pro set, think they are .040 or so. Cometic makes a .027. Might get close enough.
Maybe someone can give the actual 1160 thickness.