You're way off base Tom. Everyone is fully aware of anything I do here and why this approach makes sense from a functional standpoint. They only have to look stock on the outside, we make things better on the inside around here
Aside from that, Holley press in inserts aren't readily available, least not around here. The 6/32 set screws are available local however, and the trick works fine. Matter of fact there are a couple of long time Holley builders that prefer it. But none of that nonsense is what I was interested in. I'm not looking for your blessing. I was looking for real data on any experience you may have had vs what some of the other experts say. Like emulsion changes for instance and why some feel the fuel emulsifies better from the top than the bottom. You say it's not.....why? Give me some good points as to why. I would rather have an intelligent conversation.