More to do with the fact that I thought I had the engine at true top dead center using the dial indicator, when I slid the balancer on at that point it showed 4 degrees before. Except it all wasn't right, because I wasn't at TDC. This in turn also screwed up me degreeing the cam in the first place since I didn't find proper TDC. All is right now though! I'll always use the piston stop method from now on.
Sent from my SM-A530W using Tapatalk
__________________
1970 Trans Am, numbers matching, White, Auto, A/C, Owned since I was 15.
1973 Trans Am, numbers matching, Brewster Green, Saddle interior...Sold :-(
1978 Trans Am 400-4spd, non-numbers matching 400, Low compression daily driver, [email protected] 1/8 mile....Sold :-(
|