SO, lay the gasket paper on the block, tap the inner circumference of the dizzy hole with a ball peen hammer till thru paper.
Once you tap the inner hole thru an appropriate gasket paper, slip the dizzy thru and trace the OD of the dizzy body with a pen.
Cut the od with good scissors or shears.
You MAY find another engine dizzy gasket that will work... our in house dizzy expert... SUN TUNED, can likely tell you what engine has a similar size if you don't want to make your own.
IIRC a FE 352-428 Ford is rather large.
I make gaskets often at work for old equipment, don't even both to try and source them, can't be down that long.
|