I owned a 66 GTO since 1968. It rusted so bad that it was unsafe to drive about 20 years ago. During that time I had 12/13 motors in the car, from 326/389/455. And 350/400 SBC and 454 BBC. Transmissions ranged from 350/400 and the 4 speed muncie and a TKO600 5 speed OD. [ In my present 66 Lemans with a Ford 3:50 9". The 350 is an easy swap. It will bolt right in. Course a different flywheel is needed. The drive shaft will bolt right in. Watch out for a BOP case as chevrolet bolt pattern is different if you are buying one used. Also watch out for the ones with a lock up converter as they are not built to take the horsepower as the early ones. Also watch out because someone may try to sell you a 200 transmission as they look close to the same. The 200 has no modulator if I remember right. Rear trans mount bolts right in. The 2 speed rear mount is the same if I remember right. If you only go 40 miles out of town then the 350 is the way to go. If not I would put a 200R4 in it. I have never done that swap, but from what I read, [ I use to get every performance GM andHot Rod magazine. I still get 8/10 ] it is also a bolt in. Remember, they used it in the Grand National Turbo's. Example 3:55 rear gear 70 MPH 350/400 3200 RPM 4 speed 2900 RPM 5 speed OD TKO 600 2400 RPM and 1200 RPM at 40 MPH. I haveto hit 42 MPH before I put it in OD. Since you are stayig stock on the motor, You do not need a high horsepower transmission . I hope this info helps you.
__________________
connman
|