Yes Formulajones...we ALL know.......you're entitled!
Rough idle..but still the same knocking noise. The timing was set from the dyno and we did not adjust it. The carburetor was set at dyno and it wasn't adjusted either. We still have some adjusting to do and timing checked but this was the first start straight from the dyno. It had the same noise on the very first video of this thread!
Look carefully but you SHOULD notice that there is a bolt threaded into the carb where the stud would go so we wouldn't have a vacuum leak. Plus...Jeff sent a note which you can see here that ensured we would address that...which we did! I just took a picture of the bolt so there is no eyestrain! I'll post the pics on the next comment!
Last edited by Va68goat; 07-15-2019 at 07:02 PM.
|