Quote:
Originally Posted by Sun Tuned
Did the worn bushing distributor get replaced by a whole different one? Or just a different housing?
I didn't see the answer to this if it was mentioned earlier.
I know the initial timing has been set. But if the original shaft that had the worn bushing was reused, isthere any possibility one of the or more than one of the reluctor teeth have been dinged and firing at different time than an equal 45 degrees for each of the 8?
Does this make sense?
I've seen it before.
|
Suntuned, it's been determined that the motor has not been timed correctly and was posted on the motor prior to shipping. Appears they just need to get a timing light on it, set it properly and should be good to go.