[slowride66]

Originally Posted by ponyakr

I recently did this.

I held the engine up, slightly off the floor, with the floor crane. Set the trans up on a small dolly, bought from Harbor Freight. Can use boards of different thicknesses, if needed to change the angle.

I have waited til the engine/trans was in the car, to install converter bolts. After you tighten one bolt, you can use that bolt to rotate the flexplate, so that you can get to the next bolt. Obviously, there are other ways to rotate the flexplate.

This is the best way to turn the flywheel I have ever used. on my 3rd worn the little teeth off.

https://shop.snapon.com/product/Clut...l-Turner/A144A


SR66