Quote:
Originally Posted by tom s
Paul,Racetec did mine and the opening was too narrow to use a stock cast rod.That was with a 428 custom piston.Tom
|
Yeah, at first I thought he meant the rod was too big for the piston. But, after I went back & read post #1, it says "...can not use the factory rods because the pin end is to small..."
Don't say the pin end is too BIG, but too small.
Don't think a piston is said to have a "pin end" . A ROD does have a pin end.
So, maybe this needs to be cleared up.
Is the pin hole too small ? OR, is the outside of the pin end of the rod too big ?
