[ErikW]

Busy week. Nick built the Fab 9" housing from a Vanishing Point Race Cars Kit.(http://www.vp-racecars.com/index.html) It all starts with measuring for housing width, cutting axle tubes to rough length then trimming to final length on the lathe. Then Nick starts on housing fabrication using our homemade jig and a scrap center section. Before the back brace and housing ends are welded on the housing is welded to a beam to help avoid distortion. This whole process took several days as you have to weld and cool many times as you go. We're only allowed 5 pics per post so I'm going to make the next several posts just pics. Also included will be pics of the twin turbo "hot side" mock up.