Well after trying to install my driveshaft I found out the plug is in there. TREMEC says you can run it with the plug in there just use the driveshaft to push it past the splines. I have tried everything and the plug is frozen in place. I have done some research and the consensus is that it’s a bitch to get out. Since I put my driveshaft about 3/4 of an inch in I have pushed it a little farther in so I guess I am in for some fun getting it out. The suggestion I have seen online was screw two wood screws in the rubber then grab them both and pull it out
__________________
468/TKO600 Ford thru bolt equipped 64 Tempest Custom. Custom Nocturne Blue with black interior.
|