Quote:
Originally Posted by gto4evr
be careful cutting the hole, don't make the mistake I did of using the metal of the square dash cut out to trace on the back of the plastic to cut it out, that hole is too big and the switch will fall through it. Factory had a clamping die tool to cut that hole so that's why there's no actual dimensions on these drawings beyond a center hole. I seem to recall a member on here actually has that tool in his possession he might rent out, but obviously can be cut with a dremel, a file and alot of patience so you don't take too much off.
|
I have an original that I am replacing because it was all broken. I measured up the new one and drilled out the center. But now like you said a file and a lot of patience. Thanks, Marc.