[roger1]

Originally Posted by dataway

Nice work. I found the area over in the corner on the inside to be the biggest challenge. Several pieces of sheet metal all join in that area. You end up just kind of welding them all together.

Thanks.
Yes it gets a little complicated in that area. I put it back as close as I could get it to the way it was originally. I'm still waiting on the new firewall body mount bracket to get here.

Today, I finished repairing a couple of other floor issues.
Had some swiss cheese here that needed addressing:



I cut it all out and welded in a patch.







And this area:







Both repairs from underneath:





That is all the patching the floor will require. However, I am going to zap a little weld into several of the rust pockmarks that are left. I've done a few already.